Panel And Interface Leds; Interface Cable; Connecting The Interface Cable - 3Com 3C13701 Module Manual

3Com Router 5000 and Router 6000 v2.41
Module Guide

4.3.3 Panel and Interface LEDs

The following figures show the 1-Port 10/100/1000 FIC panel.
Figure 4-6 1-Port 10/100/1000 FIC, panel
The following table describes the LEDs on the Router 1-Port 10/100/1000 FIC panel.
Table 4-6 LEDs on the Router 1-Port 10/100/1000 FIC panel
LED
LINK
ACT

4.3.4 Interface Cable

Router 1-Port 10/100/1000 FIC uses both crossover and straight-through cables for
connection.
Figure 4-7 Ethernet cable

4.3.5 Connecting the Interface Cable

Step 1: Connect one end of the cable to the Ethernet interface on the router and the
other end to another device.
Step 2: Power on the router and check the behavior of the LINK LED on the panel. ON
means a link is present and OFF means no link is present. In the latter case, check the
line status.
OFF means no link is present; ON means a link is present.
OFF means no data is being transmitted or received. Blinking means data is being
transmitted and/or received.
Chapter 4 Flexible Interface Cards (Router 6000)
Description
4-8