Hoover SteamVac SteamVac with Clean Surge Owner's Manual page 5

1-10
Storing hose & tool
Stretch hose out and identify ends.
F. Nozzle connector end of hose
G. Trigger
Note: You may find it helpful when storing the hose and nozzle to refer to the informa-
tion on the back of the deep cleaner and on the converter end of the hose.
1-12
L
Wrap hose around hook on upper
handle (K). Press hose into clips on
upper hose holder (L).
1-15
Position stair/upholstery nozzle (models
with powered hand tool) or utility nozzle
(not included with all models) in holder
at base of cleaner and snap it into place
as shown at arrow.
G
I
H. Solution tube
I. Converter end of hose
1-13
K
L
Wrap hose around lower tool holder and
continue until nozzle connector is near
upper hose holder. Clip hose in place.
1-16
Slide bare floor attachment into holder
as shown. (Not included with all
models.)
F
H
1-11
J I
Start with converter end of hose (I). Fit
converter over tab near tool holder (j).
Press converter firmly to snap in place.
Press solution tube (H) into clip next to
converter as shown.
1-14
Press cord into cord clip on back of
hose holder. Pull cord tight.
Continued
H
5