HP Compaq dc5800 Hardware Reference Manual page 39

8. Install two M3 metric guide screws in the lower holes on each side of the drive. HP has provided
four extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3 metric
guide screws are black. Refer to
the extra M3 metric guide screws location.
CAUTION:
components of the drive.
NOTE:
the new one.
Figure 2-26
9. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
Figure 2-27
ENWW
Use only 5-mm long screws as guide screws. Longer screws can damage the internal
When replacing the drive, transfer the four M3 metric guide screws from the old drive to
Installing Guide Screws in the Optical Drive
Installing the Optical Drive
Installing and Removing Drives on page 27 for an illustration of
Installing and Removing Drives 33