Accessories / Cautions; System Configuration - Kenwood DVR-6200 Service Manual

DVR-6200
Accessories
FM indoor antenna (1)
(T90-0882-08): MEX
(T90-0907-08): K
Remote control unit (1)
(A70-1647-08): KXM
(A70-1648-08): E

SYSTEM CONFIGURATION

SYSTEM MAIN UNIT
DVT-6200 DVR-6200
Cautions
Speaker model names
2

ACCESSORIES / CAUTIONS

Loop antenna (1)
(T90-0896-08)
SCART plug adaptor (1)
(Europe only)
(E69-0012-05)
SPEAKER
KSW-6200
System Speakers
DVR-6200 KSW-6200 (Left speaker, right speaker, center speaker, surround speakers and subwoofer)
Note related to transportation and movement
Before transporting or moving this unit, carry out the
following operations.
1.Set the POWER ON/OFF switch to theON
without loading a disc.
2. Wait a few seconds and verify that the display
shown appears.
3. Set the POWER ON/OFF switch to OFF.
Manufactured under license from Dolby Laboratories.
"DOLBY", "Pro Logic" and the double-D symbol are
trademarks of Dolby Laboratories.
The marking of products using laser
(For countries other than U.S.A. and U.S.-Military)
CLASS 1
LASER PRODUCT
The marking this product has been classified as Class 1. It
means that there is no danger of hazardous radiation outside
the product.
Location: Back panel
Operation to reset
The microprocessor may fall into malfunction (impos-
sibility to operate erroneous display, etc.) w hen the
power cord is unplugged while power is ON or due to
an external factor.
In this case, switch off the power, wait for several sec-
onds, and then switch the power on again.
Return to the factory defaults by resetting the micropro-
cessor is done as shown as follows.
Video cord (1)
(E30-1427-05)
Batteries (R6/AA) (2)
Caution on condensation
Condensation (of dew) may occur inside the unit when there is a great
difference in temperature between this unit and the outside. This unit
may not function properly if condensation occurs. In this case, leave
the unit for a few hours and restart the operation after the condensa-
tion has dried up.
Be specially cautious against condensation in the following circum-
stances:
When this unit is carried from one place to another across a large
difference in temperature, when the humidity in the room wher e
this unit is installed increases, etc.
"DTS" and "DTS Digital Surround" are trademarks of
Digital Theater Systems, Inc.
s
CAUTION
VISIBLE AND INVISIBLE LASER RADIATION
WHEN OPEN. DO NOT STARE INTO THE BEAM OR
VIEW DIRECTLY WITH OPTICAL INSTRUMENTS.
DO NOT PRESS ON THIS SURFACE
Inside this laser product, a laser diode classified as Class 2 laser radia-
tion is contained as alerted by the internal caution label shown above. Do
not stare into beam or view directly with optical instruments.
Location: DVD laser pick-up unit cover inside this product
1
Press the MENU key on the remote to enter SETUP
MENU .
2
Select the PREFERENCE , then press the ENTER key.
3
Select DEFAULTS, press the Cursoe right (3) key to
select RESET.
4
Press the numeric keys as shown below.
Press 1 , 3 , 9 , 7 , then press the ENTER key.
When resetting is done according to this method, all set-
tings, including the settings for password and parental level ,
will be reset to the factory defaults .
Speaker cords (6)
(E30-5480-08): RD
(E30-5962-08): WH
(E30-7005-05): VT
(E30-5482-08): GN
(E30-5483-08): GY
(E30-5963-08): BL