User Check List - Hoover S3083-030 Owner's Manual

USER CHECK LIST

This appliance was inspected thoroughly and was in good operating
condition when it was shipped from the factory. If a minor problem
develops, it usually can be remedied quite easily when the cause is
identified. Accordingly, this check list is provided for your convenience.
PROBLEM POSSIBLE CAUSE
1. Not firmly plugged in.
A. CLEANER
2. No voltage in wall plug.
WON'T RUN
3. Blown fuse/tripped breaker.
1. Bag full.
B. CLEANER
2. Hose(s) or cleaning tool
SUCTION
clogged.
LOW
3. Secondary filter clogged.
4. Bag not opening.
5. Suction regulator control
improperly set.
6. Hose not connected to
cleaner properly.
1. Hose power cord not firmly
C. AGITATOR
plugged in.
WON'T RUN
2. Broken or worn belt.
1. Low cleaner suction.
2. Nozzle clogged.
WON'T PICK
3. Agitator not running.
UP
4. Agitator brushes worn.
If the problem persists, check the Yellow Pages of your telephone book under
"Vacuum Cleaners - Household" for your nearest Hoover Factory Service
Center or Authorized Warranty Service Dealer where approved service and
genuine HOOVER replacement parts may be obtained. The warranty provided
with this product has a listing of the Hoover Factory Service Centers. If you
are unable to obtain the information you need from the Yellow Pages, contact
a Hoover Factory Service Center to find your nearest Authorized Warranty
Service Dealer. For service under warranty, follow the instructions in the
Warranty provided with this product.
Always identify your cleaner by model number when requesting information
or ordering replacement parts. (The model number appears on the bottom of
the cleaner.)
If further assistance is needed, contact the Hoover Company Consumer
Affairs Department, North Canton, Ohio 44720,216-499-9200.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset breaker.
1. Change throw-away bag.
2. Remove foreign object.
3. Clean filter.
4. Open bag by pulling pleats.
5. Check to be sure suction
regulator is set properly.
6. Insure hose connected
properly.
1. Plug firmly into receptacle
on Cleaner base and under-
neath handle.
2. Replace belt.
1. See Item B.
2. Remove foreign object.
3. See Item C.
4. Replace brushes.
17