Pioneer AVH-P5150DVD/XN/RC Service Manual page 75

5
- How to hold the mechanism section (Fig 1)
1. Hold the main frame and the top frame.
2. As the mechanical strength of the front part of the top frame is not strong, do not hold this part.
3. Do not touch the switches provided on the top face of the mechanism section.
4. Be careful not to pull the flexible PCB on the side face.
Do not touch this part.
- How to remove the module PCB (Fig 2, Fig 3)
1. Put the mechanism section in locked state (disc load standby position).
2. Hold the mechanism module with its top face down.
3. Make the lands at 2 locations on the pick up flexible PCB short.
4. Disconnect the connectors of the pick up flexible PCB and the SPDL flexible PCB.
(Be sure to disconnect the connectors as the flexible PCB will be damaged if the PCB is removed without removing
the flexible PCB.)
5. Remove the solder joint of the lead wire of the load motor and the clamp SW.
6. Remove the two screws, and then remove the module PCB.
(Lift up point A slightly and remove it toward B direction. Be careful as the point C is connected with a flexible PCB.)
7. Disconnect the connector of the 8-12 detection flexible PCB from the PCB.
Fig 2
Short
Connector
(pick up flexible)
Solder land
(load motor, lead wire of the clamp SW.)
5
6
Do not touch this part.
Do not touch this part.
Connector (SPDL flexible)
AVH-P5150DVD/XN/RC
6
7
Fig 1
Module PCB
B
Connector
(8-12 detection flexible)
C
Fig 3
A
7
8
A
B
C
D
E
F
75
8