General Operation; Filling The Clean Solution Tank; Handle Release Pedal; The Tanks - Hoover Deep Cleaner Owner's Manual

General operation

Operate deep cleaner only at voltage specified on data plate
on back of cleaner.
ON/OFF pedal
Plug deep cleaner into a properly grounded outlet.
Step on pedal to turn deep cleaner on. Step on pedal again to
turn deep cleaner off.

Handle release pedal

Step on pedal to lower handle to operating position. Handle
does not lock into a single position but "floats" to allow conve-
nient operation.
Automatic "shut-off"
When the recovery tank (lower tank) is full, the automatic "shut-
off" mechanism will shut off the deep cleaner suction.
When this happens, the red float disk will rise to the top of the
recovery tank lid (see illustration). The deep cleaner will no
longer pick up dirty solution and the motor sound will become
noticeably higher in pitch.
When this happens, turn deep cleaner off and empty recovery
tank before continuing use.
Check clean solution tank also; it may need to be refilled.
ON/OFF
PEDAL
HANDLE
RELEASE
PEDAL
FLOAT DISK
To transport
Turn deep cleaner off before transporting.
To move your deep cleaner from room to room, put handle in
upright and locked position, tilt deep cleaner back on wheels,
and push forward.
The deep cleaner may also be lifted by placing a hand under
the upper clean solution tank handle as shown.

The tanks

Clean solution tank (upper tank)
The clean solution tank holds the cleaning solution that is to be
dispersed onto the surface to be cleaned.
How to fill
Disconnect deep cleaner from electrical outlet.
TANK
HANDLE
Place handle in the upright, locked position.
To remove tank, press down on handle and pull forward.
Carry tank to a sink.
Rotate tank cap counterclockwise and lift up to remove cap.
Continued
5