Hoover Deep Cleaner Owner's Manual page 10

HANDLE
RELEASE
PEDAL
Step on handle release pedal and lower deep cleaner handle
until it rests on the floor.
Unlatch back part of recovery tank lid and remove lid.
Remove recovery tank front panel by sliding it straight up.
Replace panel with converter. Slide converter halfway down
opening until it is firmly in place.
Before connecting tube to cleaner,
make sure black tabs are extended
by pulling tan collar toward tube.
Open door on hood labeled "Stair/Upholstery Cleaning
Connection". Press round solution tube connector onto round
projection inside door.
Press connector collar down firmly to ensure that it is fully
connected.
10
FRONT
PANEL
CONVERTER
SOLUTION
TUBE
TABS
The tank lid replaces in a hinge-like manner. Position front of
lid under tabs on front of tank. Rotate lid down onto tank.
Make sure lid is secure on all sides before cleaning.
For full suction, it is important that the recovery
tank lid is properly secured before cleaning.
Reverse procedure to remove hose and solution tube.
Raise deep cleaner handle to upright position and replace
upper clean solution tank.
TAB
Attach nozzle to connector end of hose by sliding it onto connec-
tor until the tab locks it securely.
Using your thumb, push forward and up on the latch to remove
nozzle.
Follow the instructions on pages 11-12 for the appropriate
cleaning task.
After using stair/upholstery nozzle
Follow the instructions for "After cleaning" on page 8.
Drain suction hose by turning deep cleaner ON and holding
nozzle up for several minutes. Do not press trigger.
Disconnect deep cleaner from electrical outlet.
Disconnect hose and solution tube from deep cleaner.
Drain solution tube by placing round end in sink, and raising
nozzle above your head. Press the trigger.
FRONT
LATCH