Call Hold - Panasonic G600 Service Manual

OPERATING INSTRUCTIONS
3.8 Public Man Machine Interface (MMI)
It is possible to operate all GSM telephones in the same way using the Public MMI. The following operations will
work with all GSM telephones. However, this information is restricted to those operations that are supported by
G600.
The * and # in the following procedures should be replaced by * and #, respectively. Also <SND> and <END>
should be replaced with D and E keys.
3.8.1 Reading Phonebook Memory Location
# <MEMORY LOCATION>
Leading zeros can be left out of the location number, e.g. 007 can be 7.
3.8.2 Presentation of IMEI
* # 0 6 #
3.8.3 Security
Change PIN
* * 0 4 * <OLD PIN> * <NEW PIN> * <NEW PIN> #
Change PIN2
* * 0 4 2 * <OLD PIN2> * <NEW PIN2> * <NEW PIN2> #
Unblock PIN
* * 0 5 * <PIN UNBLOCKING KEY> * <NEW PIN> * <NEW PIN> #
Unblock PIN2
* * 0 5 2 * <PIN2 UNBLOCKING KEY> * <NEW PIN2> * <NEW PIN2> #

3.8.4 Call Hold

Place a call on hold
2 <SND>
Recall a held call
2 <SND>
Make a second call
<TELEPHONE NUMBER> <SND>
Swap between two held calls
2 <SND>
End held call
O <SND>
End active call
1 <SND>
Reject incoming call
0 <SND>
MCUK980101C8 Section 3 Issue 1
Service Manual 3 - 5 Revision 0