Gvrp Settings - D-Link DES-6500 Manual

Port Settings
Tag
None
Egress
Forbidden
Click Apply to implement changes made. Click the
Static VLAN Entries window.

GVRP Settings

In the Configuration menu, open the VLANs folder and click GVRP Settings.
The GVRP Settings dialog box, shown below, allows you to determine whether the Switch will share its VLAN
configuration information with other GARP VLAN Registration Protocol (GVRP) enabled switches. In addition, Ingress
Checking can be used to limit traffic by filtering incoming packets whose PVID does not match the PVID of the port.
Results can be seen in the table under the configuration settings, as seen below.
The following fields can be set:
DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
Allows an individual port to be specified as member of a VLAN.
Specifies the port as either 802.1Q tagging or 802.1Q untagged. Checking the box will
designate the port as Tagged.
Allows an individual port to be specified as a non-VLAN member.
Select this to specify the port as a static member of the VLAN. Egress member ports are
ports that will be transmitting traffic for the VLAN. These ports can be either tagged or
untagged.
Select this to specify the port as not being a member of the VLAN and that the port is
forbidden from becoming a member of the VLAN dynamically.
Figure 6- 37. GVRP Settings and GVRP Table window
Show All Static VLAN Entries
78
link to return to the Current 802.1Q