Advertisement
4-1. ELECTRICAL ADJUSTMENTS
Service adjustments to this model can be performed using the supplied Remote Commander RM-891.
HOW TO ENTER INTO SERVICE MODE
1.
Turn on the main power switch of the set while pressing PROG + (plus) and PROG - (minus) buttons on the top panel.
2.
"TT" will appear in the upper right corner of the screen.
3.
Press the 'MENU' button twice on the remote commander to obtain the service menu on the screen.
RESET DEVICES
Backend
Deflection
Dynamic Convergence
Colour Decoder 1
Colour Decoder 2
Feature Box
PIP
Sound
4.
Push the joystick up or down on the remote commander to select the adjustment item.
5.
Push the right button to proceed to the next menu.
6.
If the required adjustment item is 'Deflection', push the down button to move to 'Deflection'.
7.
Push the joystick to the right to enter into 'Deflection'.
8.
Change the data in order to comply with each standard.
NOTE:
•
Before performing any adjustments assure that the correct model has been selected in the Model Setting menu.
•
After carrying out the service adjustments, to prevent the customer accessing the Service Menu switch the TV set OFF and then ON.
SECTION 4
CIRCUIT ADJUSTMENTS
PROGR
+
–
–
SERVICE MENU
Initialising
Reset Devices
Monitoring
Backend
Deflection
Dynamic Convergence
Colour Decoder 1
Colour Decoder 2
Feature Low - End
PIP
Special Adjustment
Select :
Next Menu
26
+
CONTROL
INITIALISING
Model Setting
Basic Setting
Feature Setting
MONITORING
Device Status monitor
Error Monitor
Production Monitor
NVM Monitor
Line 23 Monitor
Advertisement
