Technical Data - Akai AM-2200 Service Manual

I. TECHNICAL DATA
1. Power Amplifier Section
Continuous Power Output
POWER BANDWIDTH (1HF)
SIGNAL TO NOISE RATIO (1HF)
RESIDUAL NOISE
CHANNEL SEPARATION (1HF)
DAMPING FACTOR
OUTPUT
2. Pre Amplifier Section
INPUT SENSITIVITY AND IMPEDANCE
OUTPUT LEVEL AND IMPEDANCE
FREQUENCY RESPONSE
TONE CONTROL
LOUDNESS CONTROL
FILTER
3. Others
SEMICONDUCTORS
POWER REQUIREMENTS
DIMENSIONS
WEIGHT
NOTE: For improvement purposes, specifications and design are subject to change without notice.
20 watts per channel, minimum RMS, at 8 ohms from 20 to 20,000 Hz with no
more than 0.5% total harmonic distortion
10 to 45,000 Hz/8 ohms (Total Harmonic Distortion 0.5%)
Phono: Better than 85 dB
Aux: Better than 95 dB
Less than 0.8 mV at 8 ohms
Phono: Better than 55 dB at 1,000 Hz
More than 60 (1 kHz, 8 ohms)
Speakers: A,B (4 to 16 ohms)/A+B(8 to 16 ohms)
Headphone: 4 to 16 ohms
Phono: 3 mV/47 k ohms
AUX: 150 m V/ 100 k ohms
Tuner: 150 mV/100 k ohms
Tape Monitor: PIN; 150 mV/100 k ohms DIN; 150 mV/100 k ohms
TapeREC: PIN; 150 mV/100 k ohms DIN; 150 mV/100 k ohms
Phono (RIAA equalization) 30 to 15,000 Hz +-1 dB
BASS: ±9 dB at 100 Hz, TREBLE: ±7 dB at 10 kHz
+10 dB at 100 Hz, +5 dB at 10 kHz
(Volume Control set at -30 dB position)
HIGH: -6 dB at 10 kHz, LOW: -6 dB at 50 Hz
Transistors: 18, Diodes: 5, IC: 1
U.S.A. and Canada model: 120V, 60 Hz
CEE models: 220V, 50 Hz
Other models: 110/220/240V, 50/60 Hz switchable
380(W) x 125(H) x 263(D) mm
( 1 5 x 4 . 9 x 10.3) inches
5.5 kg (12.1 IDS.)