Assembling Deep Cleaner; Attach Tool Holder - Hoover Plus Owner's Manual

The assembled cleaner will look like this
drawing (Plus model shown).
1-4
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
1-7
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place.
4
Assemble handle
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
1-5
B
Place nuts in recessed areas on back
of the hose holder. Hold each nut in
place while tightening each bolt securely
(from the front of the handle) with a
Phillips screwdriver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
1-8
Press cord into cord clip on back of
handle. Pull cord tight.
1-3
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle. Push b o l t s into holes on front of han-
dle. If bolts will not go through hole easi-
ly handle is not pushed completely
d o w n .
1-6
When handle sections are completely
together, squeeze trigger (C) on upper
handle to snap trigger rod In place.
1 - 9

Attach tool holder

Remove tool and taped screw from
holder.
Insert projections on rack into slots on
back of cleaner.
A
C