Electrical Check - Sony STR-KM5000 Service Manual

1. DCAC DSP Data Line Checking
After press the [TUNING MODE] button, DCAC Factory test
mode will start, below display will show:
"DCAC x" x = 1, 2, 3, 4
If there is error happen, below display will show:
"ERR SD0x" x = 1 → D1501 or R1530 problem
x = 2 → D1502 problem
x = 3 → D1503 problem
x = 4 → D1504 problem
2. DCAC board Checking
Connect front left speaker of the receiver and AUTO CAL micro-
phone. Turn [MASTER VOLUME] jog, there will be test tone
sound output from front left speaker, and the display will change
accordingly.
"AD - xxx" xxx = 0 to 255 (depends on loudness of test tone)
RE-BOX CLASSIFICATION TEST MODE
Procedure:
1. While pressing the [MEMORY/ENTER] and [INPUTMODE]
buttons, press the [ ] button to turn on the main power.
?/1
2. The message "R.BOX[][][]XX" appears.
XX: times set powered on
VACS CONTROL TEST MODE
The VACS feature of the amplifi er is turned off purposely.
Procedure:
1. While pressing the [MEMORY/ENTER] and [2CH] buttons,
press the [ ] button to turn on the main power.
?/1
2. The message "VACS OFF" appears.
STR-KM5000
FM AUTO STOP CHECK
signal
generator
set
Procedure:
1. Turn on the set.
2. Input the following signal from signal generator to FM antenna
input directly.
Carrier frequency : A = 87.5 MHz, B = 98 MHz, C = 108 MHz
Deviation : 75 kHz
Modulation : 1 kHz
ANT input : 1 kHz
Note: Use 75 ohm coaxial cable to connect signal generator and the set.
You cannot use video cable for checking.
Use signal generator whose output impedance is 75 ohm.
3. Set to FM tuner function and scan the input FM signal with
automatic scanning.
4. Confi rm that input frequency of A, B and C are detected and
automatic scanning stops.
When the station signal is received in good condition, automatic
scanning stops.
13 13
SECTION 5

ELECTRICAL CHECK

STR-KM5000