Fujitsu Plasmavision PDS4208W-B Service Manual page 29

y
Adjusting the installation angle
• For a display installation angle of 0° to 5°
(horizontal and vertical installation)
Screw B
M5 screw with
washer (2 pcs.)
Arm
Lock fitting
Screw D
M4 screw with
washer (2 pcs.)
For an angle of 0° to 5°, fasten at two places:
the arm mounting screws A and the lock
fitting mounting screws C (4 places on both
sides).
• For a display installation angle of 5° to 15°
(horizontal installation only)
Holder R (L)
Holders R (L)
Arm
For an angle of 5° to 15°, fasten only at the
arm mounting screws B (2 places on both
sides). Remove the lock fitting mounting
screws D.
– 28 –
Screw B
M5 screw with
washer (2 pcs.)