Advanced Setup; Keypad Test - Honeywell 6280 Series User Manual

Advanced Setup

Advanced Setup allows access to Keypad Test, Keypad Reset, Night Setup and Output Setup menus.
Keypad Test - A series of diagnostic tests are provided that allows verification of correct operation of the keypad and its
connections to the security system. There are 4 diagnostic tests; LCD Display Test, Audio Test, LED Test, and Calibration Test.
When performing Diagnostic Tests, select any diagnostic test from the "Diagnostics" screen by pressing the associated Test icon.
All or any individual test may be run when you access the "Diagnostics" screen; however, each test must be performed one at a
time. At any time when a test is not being performed, you can press back to return to the previous screen or home to return to
your home page. Note: Once the Diagnostics screen is exited, subsequent entry to this screen displays all test options as "Not
Performed."
LCD Display Test
ICON
1. Press the Advanced Setup icon.
2. If applicable, enter your Authorized Code.
3. Press the Keypad Test icon.
4. Press the LCD Display Test icon.
Audio Test
ICON
1. Press the Audio Test icon; "Testing.." is displayed
while beeps sound from the speaker.
At the conclusion of the test, a pop-up "Confirmation Window" is
displayed with the question "Did you hear Beeping?"
LED Test
ICON
1. Press the LED Test icon; "Testing.." is displayed
while the 3 LEDs light sequentially, top to bottom
(red, green, yellow), 5 times.
Calibration Test
ICON
1. Select the Calibration icon and using a stylus,
follow the screen directions by pressing a series of
crosshairs (+) and boxes ( ) on the screen until done.
2
. If the test was successful, press OK; the screen
returns to the Keypad Test screen.
User Setup (cont'd)
ACTION
ACTION
ACTION
ACTION
28
NOTES
After each type of display, you are asked if the display was proper.
If the response to all questions is yes, the LCD Display Test message
area of the Diagnostics screen displays "Passed".
The Emergency screen cannot be accessed while running the LCD
Display Test.
NOTES
When you press Yes, "Passed" is displayed in the test status column
on the "Diagnostics" screen.
When you press No, "Failed" is displayed in the test status column on
the "Diagnostics" screen.
NOTES
At the conclusion of the test, a pop-up "Confirmation Window" displays:
"Did you see chasing LED pattern?"
If you press Yes, "Passed" is displayed in the test status column.
If you press No, "Failed" is displayed in the test status column.
NOTES
A pop-up message displays:
"Touch screen calibration" , "Touch crosshair to calibrate"
If the Calibration test was successful, a confirmation screen appears
stating: "Congratulations Calibration Success"
If the test was unsuccessful, an error message appears stating:
"Calibration failed, do you want to retry?" Retry, Ignore or Exit.