Honeywell 6271c Installation And User Manual

The Custom Home Page Image Converter Program allows a user to create a custom home page for their
Graphic Keypad using an existing 8 bit or 24 bit image. This program provides the capability to converting the
image only. The image to be converted can be from a camera or any photo program that can be used to make
or edit 8 bit or 24 bit bmp, jpg, or jpeg images.
Hardware Requirements
To create and install a custom home page, the following hardware requirements apply:
•
A computer running Windows XP. NOTE: The Image Converter Program needs Microsoft Framework 1.1
which is part of a normal Windows installation. If it is not on your computer, you will receive a message
that it is needed when you run the Image Converter. Framework 1.1 can be obtained and installed by
going to downloads on Microsoft.com.
•
Computer screen resolution set to 1024x768 or higher.
•
2.7 MB of available space on the computer hard drive.
•
A card reader capable of reading and writing a Multimedia Card (MMC) or SanDisk Card (SD).
•
A 32 MB to 1 GB MMC/SD card. NOTE: If using a 1GB MMC/SD card, it may come defaulted in a FAT 32
format but it must be formatted as a FAT card. You may reformat the card using the "Formatting an
MMC or SD Card" instructions at the end of this document.
•
A TouchCenter Keypad using software revision 1.1.3 or higher. NOTE: To check the software revision
level of your TouchCenter, from the "Home" screen advance to the "Advanced Setup" menu screen by
pressing the following buttons and codes as displayed;
SECURITY > MORE CHOICES > SETUP > ADVANCED SETUP > Enter Authorized Code
Your TouchCenter software revision level is displayed on the right side of the screen.
Installing the Image Converter Program
To install the Image Converter Program onto your computer, proceed as follows:
1. Go to MyWebTech and sign in as you normally do.
2. In the My Product window, enter 6271V, 6271C, or 6271CV and select go. The Image Converter Program
is the same for all three products.
3. When the product page is displayed, go to the Essential Docs area of the screen, click on "Custom Home
Page Software" and follow the instructions presented on the screen.
Creating a Custom Home Page
To create a Custom Home Page, proceed as follows:
NOTE: If you do not have a picture file that you want to use for a Custom Home Page and wish to modify an
existing standard home page, you can use any picture editor capable of modifying bmp files and load, modify,
and save wave_color_custom.bmp
Files\Honeywell\Image Converter\TemplateImages.
1. Select and open the Image Converter Program on your computer.
2. In the Image Converter Program, click on OPEN.
3. In the Open Window, select the directory that contains your picture that you want to convert into a home
page and select the file type (bmp, jpg, jpeg) of that picture.
4. From the directory, click on the picture you want and then click on the OPEN button. The image will be
displayed on the Image Converter Screen.
5. Click on the RESIZE arrow at the upper left corner of the screen.
6. Select 320x240 on the Resize drop down list.
7. Click on the COLOR DEPTH arrow at the top of the screen.
INSTALLATION AND USER GUIDE
(color) or
TOUCHCENTER KEYPAD
CUSTOM HOME PAGE
IMAGE CONVERTER PROGRAM
wave_gray_custom.bmp
K14716 8/07 Rev. A
(B&W) from directory -- Program