Oki OKIPAGE 4w Maintenance Manual page 71

Category Status Message
Paper size error Paper Size Error
Paper jam Paper Input Jam
Paper Feed Jam
Paper Exit Jam
Cover open Cover Open
Buffer overflow Page Buffer Overflow
Print Over Run
Device configuration error Program ROM Check Error
Resident RAM Check Error
Table 6-1 (Cont'd)
Status
Display Content
Code
30 00 Paper of improper size was fed.
2.52" (64 mm) L 15.77" (400.56 mm)
31 00 A paper jam occurred when sheets of paper were
being supplied.
32 00 A paper jam occurred during paper feeding.
33 00 A paper jam occurred during paper ejection.
4F 00 The upper cover is open.
40 01 The page buffer overflowed because there are a
large number of print data.
40 10 A print overrun occurred because print data is
complicated.
60 10 An error occurred during program ROM check.
60 30 An error occurred during resident RAM check.
Remedy
Check the paper. Also check whether more than one sheet of
paper were fed simultaneously. To release the error display,
open the cover, then close it. If this error occurs frequently, see
Section 6.5.2 3.
Check the paper. To release the error display, close the cover,
then close it. If this error occurs frequently, see Section 6.5.2
2-1.
Open the cover, then remove the jammed paper. To release
the error display, close the cover. If this error occurs fre-
quently, see Section 6.5.2 2-2.
Open the cover, then remove the jammed paper. To release
the error display, close the cover. If this error occurs fre-
quently, see Section 6.5.2 2-3.
To release the error display, close the cover. If this error
occurs frequently, replace the power supply board.
To release the error display, press the reset button on the
status motor of the printer driver. Install option RAM or reduce
the number of print data.
To release the error display, press the reset button on the
status motor of the printer driver. Simplify the print data format.
Replace program ROM or the main control board. (When
replacing the main control board, also adjust EEPROM data.)
(See Section 4.2.4.)
Replace the main control board. (When replacing the main
control board, also adjust EEPROM data.) (See Section 4.2.4.)