Honeywell FocusPRO TH6220D Installation Manual page 14

Installation Guide
Installer setup
Follow the procedure below to configure the thermostat to match the installed
heating/cooling system, and customize feature operation as desired.
To begin, press and hold the
buttons until the display changes
Setup Function
8 Emergency heat
cycle rate (CPH)
9 Compressor
cycle rate (CPH)
10 Second stage
compressor cycle
rate (CPH)
12 System setting
adjustment
13 Adaptive Intelli-
gent Recovery
14 Temperature
display
15 Compressor
protection
16 Schedule format
27 Heat temperature
range stops
28 Cool temperature
range stops
and
F F A A N N
Settings & Options
9 For electric emergency heat
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
5 For gas or oil furnaces of less than 90% efficiency
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
0 Manual changeover (Heat/Cool/Off)
1 Auto changeover (Heat/Cool/Auto/Off)
2 Auto changeover only (Auto)
1 On **See page 14
™ 0 Off
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time
[Other options: 0, 1, 2, 3 or 4-minute off time]
0 5/2 (programmable weekdays and weekends)
1 5/1/1 (weekdays, Saturday & Sunday programmable)
90 Highest heating temperature setting
40-89 Heating temperature range (increments of 1°F, or 0.5°C)
50 Lowest cooling temperature setting
51-99 Cooling temperature range (increments of 1°F, or 0.5°C)
Function
number
1
Done
Press
Press
N N E E X X T T
Press
D D O O N N E E
**See page 14
12
Setting
Next
or to change settings
to advance to next function
to exit and save settings
**See page 14
**See page 14
0