• This set can be assembled in the order shown below.
4-1.
ASSEMBLY FLOW
Note: Follow the assembly procedure in the numerical order given.
4-2.
GEARS INSTALLATION
3 gear (gear B)
portion A
Adjust the gear (gear B) with the
portion A as shown.
1 Slide the slider (u/d)
fully in the arrow
direction.
2 gear (U/D slider)
slider (U/D) gear
Adjust the gear so that it meshes with
the bottom tooth of slider (U/D) gear,
as shown.
SECTION 4
ASSEMBLY
4-2. GEARS INSTALLATION
(Page 21)
4-3. SLIDER (SELECTION) INSTALLATION
(Page 22)
4-4. STOCKER SECTION INSTALLATION
(Page 22)
4-5. CHASSIS (MOLD B) SECTION
INSTALLATION (Page 23)
HCD-FLX5D/FLX7D
4 gear (gear A)
gear
linearly
(gear B)
Adjust so as to be aligned with
gear B linearly, as shown.
21