Removing The Top Cover - JVC UX-M3R Service Manual

Removing the top cover

Remove the left and right side panels.
1. From the back side of the main body, loosen the
two screws D retaining the top cover.
2. Lift the rear part of the top cover to remove it.
Removing the front panel assembly
Remove the left and right side panels.
Remove the top cover.
1. Remove the tie band bundling the wires.
2. Disconnect the wire from the connector CN902 on
the power board.
3. Disconnect the wire from the connector on the
cassette switch board.
4. Remove the screw E retaining the bracket on the
ear phone board.
5. Disconnect the wires from the two connectors
CN201 and CN402 on the main board.
6. Disconnect the wires from the two connectors
CN607 and CN608 on the CD & MCU board.
7. Remove the four screws F and the two screws G
retaining the bracket of the CD mechanism
assembly from the left and right.
8. Remove the screw H retaining the front panel
assembly from the bottom side of the main body.
9. While opening the hooks d to the left and right of
the lower part of the front panel assembly (in the
direction of arrows 1), slide the front panel
assembly toward the front (in the direction of arrow
2).
[Note] After assembly, apply a locking agent to
the screws F and G.
F
G
CN607
(See Figs. 7 and 8.)
(See Figs. 9 to 11.)
CD mechanism
assembly
Fig.10
Fig.7
Lift the rear
part to remove.
D
Fig.8
CD mechanism
assembly
F
CN402
Connector on the
cassette switch
board
Power board
Fig.9
Chassis
Hook d
Hook d
Fig.11
UX-M3R
D
(To be loosened)
Top cover
Rear panel
CN201
CN608
F
G
E
Ear phone
board
Tie band
CN902
1
Front panel assembly
2
H
1
1-7