Disc Removal Method At No Power Supply - Toshiba D-VR5SU Service Manual

TAPE REMOVAL METHOD AT NO POWER SUPPLY
1. Remove the Top Cabinet, Front Cabinet and DVD Block. (Refer to item 1 of the
DISASSEMBLY INSTRUCTIONS.)
Remove the screw 1 of the Deck Chassis and remove the Loading Motor. (Refer to Fig. 2)
2.
3. Rotate the Pinch Roller Cam in the direction of the arrow by hand to slacken the Video Tape.
4. Rotate the Clutch Ass'y either derection to wind the Video Tape in the Cassette Case.
5. Repeat steps 3~4. Then take out the Video Cassette from the Deck Chassis. Be careful not to scratch the
tape.
Fig. 1

DISC REMOVAL METHOD AT NO POWER SUPPLY

1. Remove the Top Cabinet. (Refer to item 1 of the DISASSEMBLY INSTRUCTIONS.)
2. Insert a fine rod (wire etc.) into the hole of the DECK CD as shown by the arrow. (Refer to Fig. 1)
The Tray is opened.
3. Manually open the Tray.
Loading Motor
Screw 1
Pinch Roller Cam
Main Cam
Main Chassis (Front Side)
DECK CD
hole
Fig. 1
A1-6
Capstan DD Unit
Clutch Ass'y
Fig. 2
D-VR5SU/D-VR5SC