Operation Of Cisco Aironet Access Points In Brazil; Declaration Of Conformity Statements; Configuring Dhcp Option 43 And Dhcp Option - Cisco Aironet 700W Series Getting Started Manual

Operation of Cisco Aironet Access Points in Brazil

This section contains special information for operation of Cisco Aironet access points in Brazil.
Access Point Models
AIR-CAP702W-Z-K9
Portuguese Translation
Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de
estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.
English Translation
This equipment operates on a secondary basis and consequently must accept harmful interference, including interference from
stations of the same kind. This equipment may not cause harmful interference to systems operating on a primary basis.

Declaration of Conformity Statements

All the Declaration of Conformity statements related to this product can be found at the following location:
http://www.ciscofax.com
13

Configuring DHCP Option 43 and DHCP Option 60

This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP server for use with Cisco
Aironet lightweight access points. For other DHCP server implementations, consult product documentation for configuring
DHCP Option 43. In Option 43, you should use the IP address of the controller management interface.
DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a separate DHCP pool for
Note
each access point type.
The 700W series access point uses the type-length-value (TLV) format for DHCP Option 43. DHCP servers must be programmed
to return the option based on the access point's DHCP Vendor Class Identifier (VCI) string (DHCP Option 60). The VCI string
for the 700W series access point is:
Cisco AP c702
Note If your access point was ordered with the Service Provider Option (AIR-OPT60-DHCP) selected in the ordering tool,
the VCI string for the access point contains ServiceProvider. For example, a 702 with this option will return this VCI
string:
Cisco AP c702-ServiceProvider
The format of the TLV block is listed below:
• Type: 0xf1 (decimal 241)
• Length: Number of controller IP addresses * 4
• Value: List of WLC management interfaces
To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps:
Enter configuration mode at the Cisco IOS CLI.
Step 1
Create the DHCP pool, including the necessary parameters such as default router and name server. A DHCP scope
Step 2
example is as follows:
29