Statement 371-Power Cable And Ac Adapter; Industry Canada; Canadian Compliance Statement - Cisco Aironet 700W Series Getting Started Manual

English Translation
This equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices such as microwave ovens
and mobile object identification (RF-ID) systems (licensed premises radio stations and unlicensed specified low-power radio
stations) used in factory production lines.
1. Before using this equipment, make sure that no premises radio stations or specified low-power radio stations of RF-ID are
used in the vicinity.
2. If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the frequency or stop using
the device; contact the number below and ask for recommendations on avoiding radio interference, such as setting
partitions.
3. If this equipment causes RF interference to a specified low-power radio station of RF-ID, contact the number below.
Contact Number: 03-6434-6500
Statement 371—Power Cable and AC Adapter
English Translation
When installing the product, please use the provided or designated connection cables/power cables/AC adaptors. Using any
other cables/adaptors could cause a malfunction or a fire. Electrical Appliance and Material Safety Law prohibits the use of
UL-certified cables (that have the "UL" shown on the code) for any other electrical devices than products designated by CISCO.
The use of cables that are certified by Electrical Appliance and Material Safety Law (that have "PSE" shown on the code) is not
limited to CISCO-designated products.

Industry Canada

Canadian Compliance Statement

Models
AIR-CAP702W-A-K9
This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
This device complies with Class B Limits of Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Cisco Aironet Access Points are certified to the requirements of RSS-210. The use of this device in a system operating either
partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations.
For further information, contact your local Industry Canada office.
This device has been designed to operate with antennas having a maximum gain of 5 dBi. Antennas having a gain greater than
5 dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
Certification Numbers
2461B-102092
21