Preparations; Auto Setup ·20 - Denon AVR-1709 Owner's Manual

ENGLISH
Auto Setup
• Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
I
MASTER VOLUME
'-r-------r-F-F
<SPEAKERS> <SETUP MIC> ENTER,
[Front]
:"?::\-:
'~I
1
:G):
~_.~
+@
<I
D. "V
[Rear]
:~:
,
~~(~~I
<l
D. "V
l
:~.:
19
• Audyssey MultEO automatically measures the acoustical problems
in the listening environment to create the best audio experience for
your home theater.
• Audyssey MultEO optimizes a large listening area where one or
BUTTON
•
more listeners are seated.
<BUTTON>
•
Measurements are performed by placing the calibrated microphone
[BUTTON]
•
(DM-A409) successively at multiple positions throughout the
listening area as shown in Example
recommended to measure 6 positions so that the measurements
D. "V
have the proper spatial weighting.
~
Even if the listening environment is small as shown in Example (1),
measuring at multiple points throughout the listening environment
results in more effective correction.
~[::
(-:Measuring positions)
<l
r-
MASTER VOLUME
__ l
The main listening position refers to the most central position where
ENTER
one would normally sit within the listening environment.
MultEO uses the measurements from this position to calculate
speaker distance, level, polarity, and the optimum crossover value
for the subwoofer.
.4:
CJrL;'
To make manual adjustments to the settings, see pages 23 - 25.
ENTER
CD.
For best results, it is strongly
CD
Example Example
:..
........
~
(· · · · · · . . . : . . . . . .l~L . . . ~ . . . · · · · · · /
About the main listening position (*M)

Preparations

<SPEAKERS>
1 Press
A, Front B or Front A+B.
2 Set "Amp Assign" to define how the amplifier for the
surround back speaker channels is used (lI3f'page 28).
Connect the included calibrated setup microphone to
3
<SETUP MIC>.
"Auto Set Start" is displayed.
Sound
CV
receptor
Place the microphone at ear height on a tripod or stand
4
:
.
with the microphone pointing directly up towards the
\
ceiling.
"*
Do not hold the microphone in your hand during measurements.
Be sure that the path from microphone to the speakers is not
blocked by objects. Avoid placing the microphone close to a seat
back or wall as sound reflections may give inaccurate results.
S
When using a subwoofer, make the following settings before starting
the auto setup procedure:
• Defeat the volume and crossover controls if possible
• If this is not possible then set
· Volume: "12 o'clock" position
· Crossover frequency: "Maximum/Highest Frequency"
· Low pass filter: "Off"
· Standby mode: "Off"
to select the front speakers Front