Speaker Connections - Denon AVR-1709 Owner's Manual

ENGLISH
I

Speaker Connections

Example: 5.1-channels
Front speakers
Subwoofe~
I
I
Subwoofer
with built-in
amplifier
*
L : Left
R: Right
-ntO.
For surround back speakers:
• By default, the AVR-1709's "Amp Assign" setting is set to "ZONE2". To use as the surround back
speaker for the main zone, change the "Amp Assign" setting
• When using just one surround back speaker, connect it to the left channel (SBL).
For ZONE2 speakers:
• For multi-zone connection and operation, see "Amp Assign / Multi-zone Connections and Operations"
((Fpage 51 - 53).
9
A
iii 0
o
0
<=> <=>
I I
Surround speakers
(~page 28).
Connecting the Speaker Cables
Carefully check the left (L) and right (R) channels
+
and (red) and - (black) polarities on the speakers
being connected to the AVR-1709, and be sure to
interconnect the channels and polarities correctly.
Center speaker
u
Peel off about 0.03 ftil0 nun
1
of sheathing from the tip of
the speaker cable, then either
twist the core wire tightly or
=
terminate it.
Turn the speaker terminal
2
counterclockwise to loosen
it.
Insert the speaker cable's
3
core wire to the hilt into the
.speaker terminal.
Turn the speaker terminal
4
clockwise to tighten it.
When using a banana plug
Tighten the speaker terminal firmly before
inserting the banana plug.
-mu·
• Use speakers with an impedance of 6 to 16
O/ohms. When using front A and B speakers
simultaneously, use speakers with an impedance
of 12 to 16 O/ohms.
• Connect the speaker cables in such a way that
they do not stick out of the speaker terminals.
The protection circuit may be activated if the core
wires touch the rear panel or if the + and - sides
touch each other ((F"Protection circuit").
• Never touch the speaker terminals while the
power supply is connected. Doing so could result
in electric shock.
ProtectiOn
circqit
If the core wires touch the rear panel and the
screws etc., or the sides touch each other, the
±
protection circuit will be activated and the power
indicator will flash red at intervals of 0.5 secs.
If the protection circuit is activated, the speaker
output is isolated, and the power supply goes to
the standby state. If the power supply is turned
off, after the power supply cord is withdrawn,
please confirm that speaker cable and input cable
are connected.
Also, if replaying large sound levels by using
a speaker having an impedance less th'an that
specified (eg, 4 O!ohms). the temperature will
rise, and the protection circuit might be activated.
The power supply will go into the standby state,
and the power indicator will flash red at 2 second
intervals.
In this case, please switch off the power supply,
and wait until the AVR-1709 has cooled down,
and the surrounding ventilation is good .
Even if there are no problems with the surround-
ing ventilation and connections, in the event of
the protection circuit becoming activated, due to
thinking that the AVR-1709 has failed, please con-
tact DENON Service center after switching off.