Dixon ZTR 5000 Series 2000 Operator's Manual page 12

CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE:
DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:
Page 12
SPECIFICATIONS
Model ZTR 5023
11 GA - rectangular tube
Two piece - made of high-density polyethylene. Front body contains
access panels for battery service and engine to mower deck belt
removal. Rear body tilts up to allow service on the entire drive system.
Designed for operator comfort by use of high density closed cell foam
padded back and arm rests, upholstered with Cordura
fabric. Seat is adjustable fore and aft.
2 Decks are available. 60" is made of stamped steel. 50" is made of
11 GA fabricated welded construction with external reinforcement
ribs. 3 blades combine for either a 50" or 60" cut width. Cut height
approximately 1.5" to 4.5" via 7 position lift handle.
Electric clutch
Each rear wheel is independently driven by a HydroGear BDU-10L
Series 70 hydrostatic transmission. The hydrostatic transmissions, in
turn, power a fully enclosed HydroGear gearbox.
23HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve, Air-
Cooled, Gasoline, Vertical Shaft, Aluminum Head, and Crankcase with
Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type
Fuel Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition,
In-Line Fuel Filter, Dual Element Air Cleaner.
Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
Front 11 X 4 X 5 ribbed tread
Rear 20 X 10 X 8 Multi Trac
Front 16 - 21 lbs.
Rear 8 - 14 lbs.
Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 36
Engine - 2 qts. SAE 10W30 (with filter)
Width 60"(50" Deck), 72"(60" Deck)
Height 45"
Length 72"
Weight 680 lbs.(50" Deck), 685 lbs.(60" Deck)
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
TM
water-repellent