First steps
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged
and discharged.
¤ Charge the handset for 10 hours in the base.
Please note
The handset must only be placed in the designated Gigaset CX610 base or
charging cradle.
¤ After charging, remove the handset from the base and only replace it when the
batteries are fully discharged.
Please note
u Each handset is registered with the base at the factory. You do not need to
register the handset again. If you wish to use your handset with a different
base or use additional handsets with your base, you have to register the
handset manually (¢ page 54).
u After the first battery charge and discharge, you may replace your handset
in its base after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical
reasons.
12
10 h