Sony DCR-TRV6 Service Manual page 214

Page
2-2. MSW Code
Mechanism Position
UNLOAD
EJECT BL
USE
Releasing lock of
cassette compartment
Position Code
5-67
EJECT A
BL F
USE E
SOFF C
DS D
LE 9
STOP 5
FF 7
RP B
RVS 3
NULL 0
BL BL BL
SOFF DS
LS chassis movement range
Position at which the cassette compartment lock is released, and position at the farthest unload side
mechanically at which the mechanism can move no further in the UNLOAD direction.
BLANK code, at the boundary between codes. The mechanism will not stop at this code during
operations. (Excluding LOAD/UNLOAD)
EJECT completion position. When the cassette is ejected, the mechanism will stop at this position.
Cassette IN standby. The guide will start protruding out as the mechanism moves towards the
LOAD position.
Code during loading. Code outputs while the LS chassis is moving.
LS operations and guide loading are performed here.
Current limiter is turned off.
Stop position in the loading state. The pinch roller separates, the tension regulator returns, and the
brake is imposed on both reels.
FF position. The tension regulator is half on. This position is not used except for the FF mode.
PB, REC, CUE, Pause, FX2, FWD-SLOW positions. When the pinch roller is pressed, and the
tension regulator is ON, the mechanism is operating at this position in modes in which normal
images are shown.
Reverse running position. REW, REV, RX1, RX2, and RVS-SLOW are performed at this position.
Code not existing in the MD. When errors occur when the loading motor is not driving, this code is
memorized.
— 3 —
INCORRECT
BL STOP BL
LE
Contents
LOAD
BL BL
FF RP RVS
Pinch roller is pressed
Tension regulator ON