Siemens Gigaset A580IP Manual page 163

Customer Service & Assistance
Error tone sounds after system PIN prompt.
¥
You have entered the wrong system PIN.
Re-enter system PIN.
¥ Have you forgotten the system PIN?
Reset the base station to set the system PIN back to 0000 (
The other party cannot hear you.
You have pressed the k key or the
¥
Press the
When making calls from the fixed line network, the caller's phone number is not displayed
although CLIP (
¥
Calling Line Identification is not enabled.
The caller should ask his network provider to enable Calling Line Identification (CLI).
You hear an error tone when keying an input (a descending tone sequence).
¥
Action has failed/invalid input.
Repeat the operation.
Watch the display and refer to the user guide if necessary.
You cannot connect to the router and the phone is assigned a static IP address.
¥
Check on the router whether the IP address is already being used by another device in the
LAN or belongs to the block of IP addresses that is reserved on the router for dynamic
¥ address assignment.
If necessary, change the phone's IP address (
You have made a call via VoIP but cannot hear the other caller.
¥
Your phone is connected to a router with NAT/firewall.
Your STUN server (
¥
plete or incorrect. Check the settings.
£
No outbound proxy is entered or the outbound proxy mode Never is activated
( Page
¥
firewall.
Port forwarding is activated on your router, but no permanent IP address has been
assigned to your phone.
You cannot make calls via VoIP. Server not accessible is displayed.
¥
First wait a few minutes. This is often a short-term event that corrects itself after a short
time.
¥
If the message continues to be displayed, proceed as follows:
¥ Check whether your phone's Ethernet cable is correctly connected to the router.
¥
Check your router's cable connection to the Internet.
Check whether the phone is connected to the LAN. Send a ping command, e.g. from your
PC, to the phone (ping s <local IP address of the phone>). It may be that no IP address
could be assigned to the phone or a permanently set IP address is already assigned to
another LAN subscriber. Check the settings on the router, you may have to activate the
DHCP server.
162
§On§
display key to re-activate the microphone (
£
Page 43) is set.
£
Page 128) or outbound proxy (
129) and your phone is connected to a router with symmetric NAT or a blocking
§Mute§
display key. The handset is "muted".
£
Page 104).
£
Page
£
Page 99).
£
Page 46).
129) settings are incom-