Electrical Adjustment Instructions; Head Switching Position Adjustment; Test Equipment Required - FUNAI DPVR-2600 Service Manual

ELECTRICAL ADJUSTMENT INSTRUCTIONS

General Note: "CBA" is an abbreviation for
"Circuit Board Assembly."
NOTE:
1.Electrical adjustments are required after replacing
circuit components and certain mechanical parts.
It is important to do these adjustments only after
all repairs and replacements have been com-
pleted. Also, do not attempt these adjustments
unless the proper equipment is available.
2.To perform these alignment / confirmation proce-
dures, make sure that the tracking control is set in
the center position: Press either "L5 ? ? " or "K" button
on the remote control unit first, then the "PLAY"
button (Front Panel only).

Test Equipment Required

1.Oscilloscope: Dual-trace with 10:1 probe,
V-Range: 0.001~50V/Div.,
F-Range: DC~AC-20MHz
2.Alignment Tape (FL6A)

Head Switching Position Adjustment

Purpose:
To determine the Head Switching point during
playback.
Symptom of Misadjustment:
May cause Head Switching noise or vertical jitter
in the picture.
Test point
TP751(V-OUT)
TP504(RF-SW) (Switching Point)
GND
Tape
FL6A
Connections of Measurement Equipment
TP751
Main CBA GND
TP502
EXT. Syncronize Trigger Point
CH1
1.0H
CH2
Switching Pulse
Reference Notes:
Playback the Alignment tape and adjust VR501 so that
the V-sync front edge of the CH1 video output wave-
form is at the 6.5H(412.7µs) delayed position from the
rising edge of the CH2 head switching pulse wave-
form.
1-7-1
Adj.Point Mode
VR501
PLAY
(SP)
(MAIN CBA)
Measurement
Spec.
Equipment
6.5H±1H
Oscilloscope
(412.7µs±60µs)
Oscilloscope
CH1
Figure 1
0.5H
6.5H
Input
-----
CH2
Trig. (+)
V-Sync
H9300EA