Evaporator In Freezer; Thermal Fuse; Thermistor In Freezer; Ambient Thermistor - Samsung RS20NCSL Service Manual

EVAPORATOR IN FREEZER

1) Take off cover evap front, cover duct front
and cover duct rear in sequence.
2) Disconnect all wire connectors.
3) Desolder the inlet and outlet tube.
4) Remove the evaporator.
Thermistor-defrost

THERMAL FUSE

Thermal fuse is located at top of the evaporator.
1) Disconnect the wire connector of thermal fuse.
2) Cut the cable tie for securing the fuse.
3) Separate the fuse from the evaporator.
Do not desolder evaporator to replace
the fuse only.
THERMISTOR DEFROST
Thermal fuse is located on accumulator of
evaporator.
1) Disconnect the wire connector of thermistor-
defrost.
2) Cut the cable tie for securing the thermistor.
3) Separate the thermistor from the evaporator.
Do not desolder evaporator to replace the
thermistor only.

THERMISTOR IN FREEZER

Before disassemble the thermistor, Should be
removed cover duct. front.
1) Remove the sensor cover.
2) Separate thermistor.
Thermal
Fuse
The thermistor is located at inside the upper
hinge cover. It sends temperature signal to the
micro-processor.
19
Sensor

AMBIENT THERMISTOR