Icom IC-F5061/D Instruction Manual page 11

Vhf mobile transceiver/uhf mobile transceiver
Hide thumbs Also See for IC-F5061/D:
Table of Contents

Advertisement

WIDE/NARROW KEY
Push to toggle the IF bandwdth between wde and narrow.
(Analog or mxed mode operaton only)
• The wde passband wdth can be selected from 25.0 or 20.0 kHz
usng the CS-F5060
cloning software
your dealer for detals.
DTMF AUTODIAL KEY
Push to enter the DTMF channel selecton mode. Then select
the desred DTMF channel usng [CH Up]/[CH Down].
After selectng the DTMF channel, push agan to transmt
the selected DTMF code.
RE-DIAL KEY
Push to transmt the last-transmtted DTMF code.
• TX memores are cleared after turnng the transcever OFF.
CALL KEYS
Push to transmt a 2/5-tone/BIIS ID code.
• Call transmsson s necessary before callng another staton
dependng on your sgnallng system.
• [Call A] and/or [Call B] may be avalable when your system
employs selectve 'Indvdual/Group' calls. Ask your dealer whch
call s assgned to each key.
. (PMR operaton only) Ask
PANEL DESCRIPTION
EMERGENCY KEY
Push and hold to transmt the emergency call.
• The emergency call transmts wth beeps; the dsplay does not
change.
• The transcever can transmt the emergency call slently or wth the
dsplay changes dependng on the pre-settng. Ask your dealer for
detals.
• If you want to cancel the emergency call, push and hold the key
agan before transmttng the call.
• The emergency call s transmtted one tme only or repeatedly untl
recevng a control code, dependng on the pre-settng.
SURVEILLANCE KEY
Push to turn the survellance functon ON or OFF.
When ths functon s turned ON, the beep s not emtted and
the LCD backlght and the LED ndcator do not lght when a
sgnal s receved or a key s pushed.
TX CODE ENTER KEY (PMR operaton only)
Push to enter the ID code edt mode drectly, for both
5-tone and MSK. Then set the desred dgt usng [CH Up]/
[CH Down]. (p. 11)
TX CODE CHANNEL SELECT KEY
➥ Push to enter the ID code channel selecton mode
drectly. Then set the desred channel usng [CH Up]/
[CH Down]. (p. 10)
➥ Durng ID code channel selecton mode, push for 1 sec.
to enter the ID code edt mode for 5-tone and MSK. Then
set the desred dgt usng [CH Up]/[CH Down]. (p. 11)
1
1
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ic-f5063Ic-f6061dIc-f6063Ic-f5061Ic-f6061

Table of Contents