Kenwood 00271-13000 Instruction Manual page 30

Installing in Japanese-Made Cars
1
Refer to the section <Removing the hard rubber frame> (page
31) and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
N
T
N
T/N
T
T: Toyota cars
N: Nissan cars
• During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
8 mm
8mm
MAX.
MAX.
2
3
ø5mm
ø5mm
Accessory2...for Nissan car
Accessory3 ...for Toyota car
— 30 —
Screwing the Faceplate on the Unit
Never insert the taptite screw (ø4
than the one specified. Iw37T9827hed. Iw3Faceplate on the Unit
16 mm) in any other screw hole