Table of Contents
Advertisement
Land Pride
Section 3: Adjustments
Refer to Figure 3-8:
5. Set cutting height at 3 1/4" on the height indicator by
placing the height adjusting stop in the 3" hole, and
turning the height adjustment stop so that the flat
side is against the stop handle.
6. Clamp the height adjusting stop against the stop
handle. This will assure that the height will not move
during the setting process. Otherwise, spring
pressure from the deck lift springs will tend to pull the
stop away from the handle.
Stop Handle
23626
Cutting Height (Right Side Shown)
Figure 3-8
Refer to Figure 3-9 & Figure 3-10.
7. On both sides of the mower, loosen all nuts on the
deck lift threaded rods and hardware on the adjuster
until all deck lift chains are loose and the deck is
sitting tightly on all three blocks.
Nuts
Deck Lift Chains
Deck Level Adjustment (Right Side Shown)
Figure 3-9
2/27/07
Z44 & Z52 (S/N 472620 -526170) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor
Table of Contents
Height Adjusting Stop
Deck Lift
Threaded Rod
Nuts
23626
Adjuster
Hardware
Deck Level Adjustment (Right Side Shown)
Figure 3-10
Refer to Figure 3-11:
8. Loosen the two nuts on the front of height indicator
so that the foot pedal is free.
Foot
Pedal
Nut
Left Front
Deck Lift Chain
23690
Deck Lift Rod Adjustment (Left Side of Foot Pedal Shown)
Figure 3-11
5/16"
Adjuster Bolt
Jam Nut
23626
Deck Lift
Block
Height
Indicator Rod
Nut
®
357-044M
23
Advertisement
Table of Contents
