Main Unit - Honeywell TN924W User Manual

Measures wind speed
C. ANEMOMETER BASE
•
Holds battery compartment
•
Allows mounting the anemometer vertically
D. ANEMOMETER ARM
Keeps anemometer assembly together
H
G
F
E. WIND CUPS SHAFT
Holds wind cups on the anemometer arm
F. BATTERY COMPARTMENT
Holds 2 AA-size batteries
G. SET OPENING
Allows toggling wind direction between factory pre-set and default set (North)
H. WALL MOUNT SCREW OPENINGS
Allow securing the anemometer in place
I. BATTERY COVER
Allows securing 2 AA size batteries on the anemometer base
ASSEMBLY
•
Place the wind cups (B) over the wind cups shaft (E) of the anemometer arm
(D)
•
Insert the wrench tool provided into the wind cups opening
•
Loosen the small screw inside and tighten it
•
Test if the wind cups (B) sit secure on the wind cups shaft (E)
E
I
11
BATTERY INSTALLATION and ALIGNING
•
Remove four (4) screws from the battery compartment with a small Phillips
screwdriver
•
Open the battery compartment and install 2 "AA" size alkaline batteries (not
included) matching the polarities shown
•
Point the wind vane (A) to the north (use a compass or map if necessary). The
default direction is NORTH when the wind direction vane (A) is in parallel with
an anemometer arm (D)
•
Watch that the main display unit in the Wind Window displays the wind
direction arrow pointing to the NORTH
•
If the wind direction arrow in the Wind Window does not show NORTH, press
SET opening (F) located inside battery compartment with a paper clip or similar
tool
•
Replace the battery cover (I) and secure the screws
NOTE: Repeat this procedure every time when changing the batteries.
MOUNTING
Mount the anemometer onto a vertical surface, using the fittings provided.
PLACEMENT
•
The anemometer should be mounted in an open area with a free air flow; away
from the nearby trees, buildings or other structures
•
It is suggested mounting anemometer at 33 feet (10meters) above the ground
in unobstructed area

MAIN UNIT

Weather Radio receives all NWS alert signals broadcast within approximately 40 miles
(65 km) radius.
The Weather Station measures pressure, indoor temperature, humidity and receives
atomic time signal from the US Atomic Clock located in Fort Collins, Colorado and all
remote weather sensors. It should be placed indoors.
FEATURES
Radio
• NOAA SAME Technology
• Public Alert Certified Device
Weather
•
Weather forecast for the next 12 to 24 hour in seven large icons: Sunny,
Partly Cloudy, Cloudy, Light Rain, Heavy Rain and Snowy
•
Barometric pressure in imperial or metric units
•
Altitude adjustment for pressure compensation
12