Installation/Connection; Part List For Installation; Installing The Unit (In-Dash Mounting) - JVC KW-R710 Instruction Manual

z
0
-
1 -
u
w
z
z
0
u
...........
z
0
-
1 -
c
...1
...1
c
....
"'
z
-
18
A
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car
chassis or Ground wire (black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car's chassis again after installation.
A
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the
car audio dealer .
• Install this unit irr the console of your vehicle. Do nottouch the metal
parts of this unit during and shortly after use of the unit. Metal parts such
as the heat sink and enclosure become hot.
• Do not connect the
8
wires of speakers to the car chassis or Ground wire
(black), or connect them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the
maximum power of the speakers is lower than 50 W,.change the
[AMP GAIN]
setting to avoid damaging the speakers. (+ 12)
• Mount the unit at an angle of less than 30°.
• If your vehiclewiring harness does not have the ignition terminal,
connect Ignition wire (red) to the terminal
on
the vehicle's fuse box
which provides _12 V DC power supply and is turned on and off by the
ignition key._
• After the unit is installed, check whether the brake lamps, blinkers,
wipers, etc. on the car are working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis,
then replace the old fuse with Qne that has the same rating.
Basic procedure
1 Remove the key from the ignition switch, then
disconnect thee terminal of the car battery.
2 Connect the wires properly.
See Wiring connection.(+ 19)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the
8
terminal of the car battery.
5 Reset the unit.(+ 3)
Part list for installation
(A)
Wiring harness
( xl )
'
I
I
I.
(B)
Flat head screw
M5
X
8 mm (M5 x 3/8 11
)
( x8)
Installing the unit (in-dash mounting)
I
: (C)
Round head screw
MS
X
8 mm (M5
X
3/8 11
)
( x8)
A
Use only the specified screws. Using wrong screws might damage the unit.
8 mm (3/8") 8 mm (3/8")
~
I
\.
///.
~-
(A)
Mounting bracket
removed from the car
*
Screw removed from the car.
If there is an interfering tab
on the mounting bracket,
benditflat.