Honeywell QuietCare HCM-6009 Owner's Manual page 13

QuietCare_Console_OM_Rev1.qx
Troubleshooting (Continued)
PROBLEM
Humidity display is too high
(Models HCM-6012i, HCM-
6013i)
Filter turns brown
Condensation forming on
the windows and/or walls
Humidifier has strange odor
or unit does not seem to be
as clean as when I
purchased it
The humidifier cycles on/off
Water leaks from tank
Tank cap is too tight
8/25/06 1:32 PM
POSSIBLE CAUSE
Moisture/condensation accumulated
in the humidity sensor
Unit is overfilled with water
Filter may need to be replaced
Humidity level is set too high
Unit is placed too close to the wall
and/or windows
Need to replace Protec™ Cleaning
Cartridge
Unit needs to be cleaned
The humidifier is responding to
your room humidity based on the
humidistat setting. This is normal.
Rubber tank ring is missing or
improperly placed
Tank cap not tight enough
Tank cap over tightened
Page 13
CORRECTIVE ACTION
Turn off the unit and completely dry out the unit
Drain the excess water from the base and
completely dry out the unit
If you filter is light brown or rust colored after a
short amount of time it's probably from mineral
deposits. Soak filter in a sink full of cool water
to help break up the deposits. The
discoloration may remain but it should not
affect the humidifier's performance. If you
notice a performance decrease or live in a hard
water area you may have to replace your filter
more regularly. Replace your filter (Model HC-
14). Visit the retailer you purchased your unit
from or call 1-800-477-0457.
Reset humidity to a lower level and/or reduce
the output level.
Relocate the unit
If you have been using your humidifier for over
30 days chances are you need to replace the
Protec™ cartridge. (Models: PC-1 or PC-2).
Visit the retailer you purchased your unit from
or call 1-800-477-0457.
Clean your unit as directed in the Cleaning
section. Regular cleaning is recommended to
keep the unit functioning properly.
Set the humidistat to a higher or lower desired
setting. If you do not want your unit to cycle
on/off periodically run your unit on "Continuous
Mode". See operating instructions.
Remove tank cap then replace or reposition the
ring. Make sure the cap spring valve operates
freely.
Tighten the cap
Lightly lubricate the cap gasket with petroleum
jelly to ease opening.
13