Honeywell WSK-24 Installation Instructions Manual page 5

INSTALLATION
Fig. 6. Door sensor bracket mounting.
4. Make sure the notched side of the door sensor is
pointing in the direction that you will mount the
magnet. See Fig. 7 and Fig. 8.
TAB
NOTCHES
Fig. 7. Door sensor tab notches.
5. Snap the sensor in place.
6. Align one end of the magnet with the notched side
of the door sensor housing.
7. Mount the magnet a maximum of 3/4 in. (19 mm)
from the door sensor, as illustrated in Fig. 8.
TAB
NOTCHES
MUST FACE
THE MAGNET
1
1
MAXIMUM DISTANCE BETWEEN SENSOR AND
MAGNET 3/4 (19).
Fig. 8. Maximum distance between door sensor and
SCREWS TO
HOLD BRACKET
MOUNTING
BRACKET
TAB TO RELEASE
DOOR SENSOR
ADHESIVE
TAPE
M29153
TAB
NOTCHES
M29154
M29155
magnet.
WSK-24 WIRELESS OCCUPANCY SOLUTION
8. Secure the magnet to the door by using the two
screws or adhesive tape provided. An optional
spacer is provided, as well. See Fig. 9.
Fig. 9. Door magnet mounting options.
9. Open and close the door to ensure that there is no
interference.
CHECK THE DOOR SENSOR FUNCTION
1. Open the door and verify that the LED on the door
sensor flashes three times when the contact is
opened.
2. Close the door and verify that the LED on the door
sensor flashes another three times.
Mounting the PIR Occupancy Motion Sensor
PLASTIC
CONICAL
ANCHORS
ADHESIVE
TAPE
MOUNTING
SCREWS
BRACKET
TO FIX THE
BRACKET
Fig. 10. PIR occupancy motion sensor mounting
1. Take off the cover by removing the cover release
screw on the bottom of the PIR back plate.
2. Power the PIR sensor by inserting the three AAA
batteries provided. See Fig. 12 for proper battery
orientation.
3. Secure the PIR sensor to the wall using one of the
following three options
5
SCREWS TO
MAGNET OR
SPACER
OPTIONAL
SPACER
ADHESIVE
TAPE
SCREWS
TO HOLD
SENSOR
PIR BACK
PLATE
SCREW TO
RELEASE
COVER
options.
62-0300ES—01
M29156
COVER
M29157