Technical Information - AEG L 70270 FL User Manual

Water connection
• Do not connect the appliance with old
hoses already used. Only use new ho-
ses.
• Make sure not to cause damage to the
water hoses.
• Do not connect the appliance to new
pipes or pipes not used for a long time.
Let the water flow for some minutes,
then connect the inlet hose.
• The first time you use the appliance,
make sure that the water hoses and the
couplings do not have leakages.
Electrical connection
• Make sure that the appliance is earth-
ed.
• Make sure that the electrical informa-
tion on the rating plate agrees with the
power supply.
• Always use a correctly installed shock-
proof socket.
• Do not use multiple plugs and exten-
sion cables. There is a risk of fire.

TECHNICAL INFORMATION

Dimensions
Electrical connection:
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture
Water supply pressure
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Maximum
• Do not replace or change the mains ca-
ble. Contact the service centre.
• Make sure not to cause damage to the
mains plug and cable.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access to
the mains plug after the installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
DISCARD THE APPLIANCE
1. Disconnect the mains plug from the
mains socket.
2. Cut off the mains cable and discard it.
3. Discard the door catch. This prevents
children or pets to be closed in the
appliance. There is a risk of suffoca-
tion (only for front-loading applian-
ces).
1200 rpm (L 70270 FL)
1400 rpm (L 70470 FL)
ENGLISH
5
600 / 850 / 522 mm
540 mm
230 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
7 kg