Reading Techniques; Resetting The Standard Product Defaults - Honeywell 2020 User Manual

Reading Techniques

The image scanner has a view finder that projects a bright red aiming beam that
corresponds to its horizontal field of view. The aiming line should be centered
horizontally over the barcode; it will not read if the aiming line is in any other
direction.
Good Read
Bad Read
The best focus point for reading most code densities is about 5 inches (12.7
cm) from the unit. To read single or multiple symbols (on a page or on an
object), hold the image scanner at an appropriate distance from the target, pull
the trigger, and center the aiming line on the symbol.

Resetting the Standard Product Defaults

If you aren't sure what programming options are in your image scanner, or
you've changed some options and want the factory settings restored, scan the
Standard Product Default Settings barcode below.
The Menu Commands
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this barcode also causes both the image scanner and the base
to perform a reset and become unlinked. Refer to
Scanner to Base"
1 - 20
starting on page 10-6
on page 1-5 for additional information.
Standard Product Default Settings
Bad Read
lists the factory default settings for
"Linking Image