Mackie S215 Repair Manual page 7

High Frequency Driver replacement continued:
locking washer locking washer
8 8
Four nuts and eight washers may be
removed from the driver using the
8mm open end wrench. Turn counter-
clockwise to loosen and remove,
clockwise to tighten. The other three are
located around the horn assembly. Lift
the horn up as the nuts are loosened. It
cannot be removed otherwise. Notice
that the fl at washer is on the bottom,
followed by the locking washer, and
fi nally the nut.
9 9
Keep the four nuts, four locking washers,
and four fl at washers in a safe place.
headless headless
screw screw
nut nut
fl at washer fl at washer
10 10
The horn assembly should easily lift
right off of the high frequency driver.
7