Set Up The Dhcp Server On Your Access Point; Copyright 2014 Trendnet. All Rights Reserved - TRENDnet TPL-410AP User Manual

TRENDnet User's Guide

Set up the DHCP server on your access point

Main > DHCP Server
Your access point can be used as a DHCP (Dynamic Host Configuration Protocol) server
to automatically assign an IP address to each computer or device on your network. The
DHCP server is disabled by default on your access point. In most cases your network
router has a built-in DHCP server that is typically enabled and used as your network
DHCP server. If you already have a DHCP server on your network, leave this settings
disabled.
1. Log into your access point management page (see
management page" on page 9).
2. Click on Main, and click on DHCP Server.
3. Review the DHCP Server settings. Click Save Settings to save settings.
• Enable: Check to enable or uncheck to disable the DHCP server.
• IP Pool Starting Address – Enter the starting IP address for the DHCP server
range. (e.g.192.168.10.200)
• Pool Size – Enter the maximum number of address the DHCP server is able to
50, the DHCP server will issue 192.168.10.200-250
distribute. (e.g.
Note: The Start IP and End IP specify the range of IP addresses to automatically
assign to computers or devices on your network.
• Release Time – Enter the DHCP lease time in seconds.
Note: The DHCP lease time is the amount of time a computer or device can keep
an IP address assigned by the DHCP server. When the lease time expires, the
computer or device will renew the IP address lease with the DHCP server,
otherwise, if there is no attempt to renew the lease, the DHCP server will
reallocate the IP address to be assigned to another computer or device.
© Copyright 2014 TRENDnet. All Rights Reserved.
"Access your access point
)
4. To save changes, click Save. When prompted to Save or Continue, you can click Save
to apply the changes or click Continue to additional changes in the access point
management page before saving.
TPL-410AP / TPL-410APK
23