Motorola MCP750 Installation And Use Manual page 128

CNFG and ENV Commands
6
6-6
Auto Boot Scan Enable [Y/N]
Y
N
Auto Boot Scan Device Type List = FDISK/CDROM/TAPE/HDISK?
This is the listing of boot devices displayed if the Autoboot Scan
option is enabled. If you modify the list, follow the format shown
above (uppercase letters, using forward slash as separator).
Auto Boot Controller LUN
Refer to the PPCBug Firmware Package User's Manual (listed in
Appendix B, Related
controller modules currently supported by PPCBug. (Default = $00)
Auto Boot Device LUN
Refer to the PPCBug Firmware Package User's Manual for a listing
of disk/tape devices currently supported by PPCBug.
(Default = $00)
Auto Boot Partition Number = 00?
Which disk "partition" is to be booted, as specified in the PowerPC
Reference Platform (PRP) specification. If set to zero, the firmware
will search the partitions in order (1, 2, 3, 4) until it finds the first
"bootable" partition. That is then the partition that will be booted.
Other acceptable values are 1, 2, 3, or 4. In these four cases, the
partition specified will be booted without searching.
Auto Boot Abort Delay = 7?
The time in seconds that the Autoboot sequence will delay before
starting the boot. The purpose for the delay is to allow you the option
of stopping the boot by use of the
0-255 seconds (Default = 7 seconds).
Auto Boot Default String [NULL for an empty string] =?
= Y?
If Autoboot is enabled, the Autoboot process attempts
to boot from devices specified in the scan list (for
example,
FDISK/CDROM/TAPE/HDISK
If Autoboot is enabled, the Autoboot process uses the
Controller LUN and Device LUN to boot.
= 00?
Documentation) for a listing of disk/tape
= 00?
key. The time value is from
BREAK
Computer Group Literature Center Web Site
) (Default).