Motorola MCP750 Installation And Use Manual page 126

CNFG and ENV Commands
6
6-4
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Y
N
Network PReP-Boot Mode Enable [Y/N] = N?
Y
N
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Y
N
Primary SCSI Bus Negotiations Type [A/S/N] = A?
A
S
N
Primary SCSI Data Bus Width [W/N] = N?
W
N
Secondary SCSI Identifier = "07"?
If the board has a secondary SCSI controller, this number is the secondary
SCSI ID or address. For the MCP750, all PCI add-on SCSI
controllers/adaptors supported by PPCBug are set to the SCSI ID value
entered here.
NVRAM (PReP partition) header space will be
initialized automatically during board initialization,
but only if the PReP partition fails a sanity check
(Default).
NVRAM header space will not be initialized
automatically during board initialization.
Enable PReP-style network booting (same boot image
from a network interface as from a mass storage
device).
Do not enable PReP-style network booting (Default).
SCSI bus is reset on debugger setup.
SCSI bus is not reset on debugger setup (Default).
Asynchronous SCSI bus negotiation (Default).
Synchronous SCSI bus negotiation.
None.
Wide SCSI (16-bit bus).
Narrow SCSI (8-bit bus) (Default).
Computer Group Literature Center Web Site