Advertisement
ASSEMBLY
1. Secure the landside to the frog with two
x
tighten. Next, mount the brace between
the moldboard and the landside with
plow bolts and square nuts. Tighten all
1
bolts securely.
Assemble the standard to the landside
2.
assembly after inserting the land
adjusting bolt
x
t a b
on the standard and into the square
nut. Then install the carriage bolt and
square nut at the top hole, and the
plow bolt and square nut (not shown)
at the remaining hole in the landside, frog,
and standard. Tighten the bolts securely.
3 . Position the beam assembly over the
standard and secure with two
hex bolts, lock washers, and hex nuts;
tighten securely.
Install the beam assembly on the mast
4.
using two U-bolts (saddled from the front),
lock washers, and hex nuts.
NOTE:
If the tractor rear wheels
in narrow tread position, position the beam
as shown.
If wheels
are set wide. locate the
beam as outlined.
( S e e
'OPERATION section.)
5.
Install the spacer between the mast
at the bottom hole. Secure with a
hex bolt, lock washer. and hex hut.
2 1 / 1 3 "
Install the link pins and secure them with
6.
hex j a m nuts, lock washers. and hex
nuts.
Use holes
NOTE:
X- X for
or larger tires: use holes
x 15"
tires.
x
.
x
hex) through the
x
x 2*h"
are
set
Width
o f
C u t
in
arms
x
tractors with
8.00
with
8.00
BOLTS.
LOCK WASHERS,
NUTS
CARRIAGE BOLT,
BEAM
Beam position
with rear wheels
for narrow
s e t
tread; approx. 21
between tires.
Use with 8.00 x
BEAM ASSEMBLY
LAND ADJUSTING
BOLT, Ye"
2%"
X
\
Beam position
with rear wheels
set
for wide tread;
tread; approx. 30"
between tires.
12" tires
Advertisement
