DIS DC 6190 P Datasheet

DC 6190 P Conference Unit
• Chairman and delegate functionality in one unit
• Lockable XLR microphone connector
• Loudspeaker
• Two channel selectors and two OLED displays
• Exchangeable buttons
Description
The DC 6190 P is a fully digital portable conference unit in the DIS DCS 6000
Digital Conference System.
The unit can be configured either as a chairman or a delegate unit. The unit's de-
fault configuration is the delegate configuration.
To configure the unit the mute and the microphone button must be held down while
pressing the left volume up button for 10 seconds to obtain chairman functionality
or the left volume down button for delegate functionality. The button light guides
flash when the unit is configured and the unit reboots. The configuration is stored
in the unit so it recalls its configuration if it is used in another system setup.
The left button is a function button that changes functionality depending on the
configuration. The chairman configuration enables 'all delegates off' functionality
in the left button while the delegate configuration enables 'mute' functionality in the
left button.
The function button can be changed to match the current functionality by pushing
the button out of the unit from below. The new button is then simply pressed into
the unit.
The all delegates off button enables the user to turn off all active delegate
microphones.
The mute button enables the user to temporarily mute the active microphone while
the mute button is held down.
The microphone button enables the user to activate/deactivate the microphone.
The floor channel is distributed through the built-in loudspeaker except when the
microphone is turned on. The user can also listen to the floor channel or one of the
31 interpretation channels by inserting headphones in the two headphone jacks
and adjusting the volume with the volume buttons.
The gooseneck microphones GM 652x or GM 6622 can be locked to the unit with
a 1.5 mm hex key. The lock is accessible from the small hole below the DIS logo
on the side of the XLR socket. Turn the hex key counter clockwise to lock the
gooseneck microphone to the unit and turn the hex key clockwise to unlock the
gooseneck microphone from the unit.
The DC 6190 P can be combined with any conference units from the DCS 6000
Digital Conference System.
DIS Digital Conference Systems
DC 6190 P Conference Unit
Features
The DC 6190 P has the following standard features:
• Standard conference unit for chairmen and delegates
• Fully digital audio transmission
• Daisy chain topology with loop-through connections or star
topology using junction boxes
• CAT 5e (or higher) F/UTP or U/FTP cabling
• Maximum 3800 conference units per system
• Support for four microphone operation modes; Automatic,
FIFO, Manual and VOX (voice activation)
• Support for three microphone interrupt ability modes enabling
'ping pong' mode
• Auto off of microphones
• Lockable XLR gooseneck microphone connector
• One high-quality loudspeaker
• Two channel selectors supporting the floor channel and 31
interpretation channels
• Two headphone sockets
• Microphone and function (all delegates off/mute) buttons
• Exchangeable buttons for changing the button labels to other
languages and other functionality
DS-DC6190 P-e