Kenwood TK-863G Service Manual page 4

TK-863G
1-5. Programmable Auxiliary Functions
You can program the
MON, A, D/A, , , and SCN keys with the functions listed
below.
• AUX
• Display Character
• DTMF ID (BOT)
• DTMF ID (EOT)
• Emergency * 1
• Group Down
• Group Up
• Home Group
• Horn Alert
• Key Lock
• Memory (RCL)
• Memory (RCL/STO)
• Memory (STO)
• Monitor Momentary
• Monitor Toggle
• None (No function)
• Public Address
• Redial
• Scan
• Scan Del/Add
• Scan Temporary Delete
• Squelch Off Momentary
• Squelch Off Toggle
• System Down
• System Up
• Telephone Disconnect
• Volume Down
• Volume Up
*1 : This function can be used only with a foot switch.
2. Operation Features
The TK-863G is a UHF FM radio designed to operate in
trunking format. The programmable features are summa-
rized.
3. Transceiver Controls and Indicators
3-1. Front Panel Controls
All the keys on the front panel are momentary-type push
buttons. The functions of these keys are explained below.
• POWER key
Transceiver POWER key. When the power is switched
off, all the parameters are stored in memory. When the
power is switched on again, the transceiver returns to the
previous conditions.
4
OPERATING FEATURES
/ (left side), / (right side),
• SYSTEM UP/DOWN key (Programmable)
• / key (Programmable)
• SCAN key (Programmable)
• MONITOR key (Programmable)
• A, D/A key (Programmable)
• VOLUME UP/DOWN key (Programmable)
• TX LED
The TX indicator (Red LED) shows that you are transmit-
ting.
3-2. Programmable Keys
The FPU (KPG-76D) enables programmable keys to se-
lect the following functions.
None, AUX, DTMF ID (BOT), DTMF ID (EOT), Display
Character, Emergency, Group Down, Group Up, Home
Group, Horn Alert, Key Lock, Memory (RCL/STO), Memory
(RCL), Memory (STO), Monitor Momentary, Monitor Toggle,
Public Address, Redial, Scan, Scan Del/Add, Scan Tempo-
rary Delete, Squelch Off Momentary, Squelch Off Toggle,
System Down, System Up, Telephone Disconnect, Volume
Down and Volume Up.
• AUX
If this key is pressed, "AUX" icon lights on the display
and AUX port which is inside of the transceiver turns to the
active level. If pressed again, the "AUX" icon goes off and
the AUX ports turns to the lower level.
• Display character
This key switches the LCD display between the system
and group number and the system and group name.
• DTMF ID (BOT)
In conventional mode, if you press this key, a predeter-
mined DTMF ID (Begin of TX) will be sent automatically.
• DTMF ID (EOT)
In conventional mode, if you press this key, a predeter-
mined DTMF ID (End of TX) will be sent automatically.
• Emergency
Pressing this key for longer than the programmed "Emer-
gency Key Delay Time" causes the transceiver to enter the
Emergency mode and display the "Emergency Display" set-
ting. The transceiver automatically switches to the "Emer-
gency System/Group" and transmits for the programmed
"Duration of Transmission Mode".
The transceiver disables MIC mute while transmitting.
After finishing transmission, the transceiver receives for the
programmed "Duration of Receiving Mode". The trans-
ceiver mutes the speaker while receiving.