Download Print this page

Radio Shack 14-Inch DBS Compatible TV Antenna with 24-Inch Dipoles Owner's Manual page 3

14-inch dbs compatible tv antenna with 24-inch dipoles

Advertisement

the outside diplexer with weather-resistant tape, available
at your local RadioShack store.
Antenna Cable
ANT Connector
Outside
Diplexer
Cable to Diplexer
Inside the House
5. Follow these guidelines to route the coaxial cable from the
outside diplexer's
SAT/ANT
• Use plastic tape or mast standoff insulators to secure the
coaxial cable to the mast at about 3-foot intervals. Con-
tinue down the roof and the side of the house using roof
and wall standoff insulators.
• Use coaxial cable nail-in clips every few feet to secure
the cable between the mast and where the cable enters
the house.
• Use a 75-ohm grounding block at the point where the
coaxial cable enters the house. Read the Consumer
Product Safety Commission sheet for grounding instruc-
tions.
• Use a wall-through lead-in tube (not supplied) to neatly
route the coaxial cable through walls.
6. Connect the coaxial cable from the outside diplexer to the
connector of the other diplexer inside the house.
SAT/ANT
Attach one end of a short length of coaxial cable to the
inside diplexer's
connector. Connect the other end to
SAT
the satellite receiver's satellite in connector. Attach one end
of another short length of coaxial cable to the inside
Satellite Dish Cable
SAT Connector
SAT/ANT Connector
connector into the house.
diplexer's
connector. Connect the other end to the sat-
ANT
ellite receiver's antenna in connector.
Satellite In
Connector
SAT Connector
Cable to Diplexer
Outside the House
7. When you finish making all connections, rotate the antenna
to a position that gives you the best reception.
For Local Reception Only
To mount the antenna by itself for local reception only, you will
need a mast and mast mounting hardware, available at your lo-
cal RadioShack store.
With the antenna's bottom side facing downward, slide the an-
tenna's U-bolt over the top of the mast. Tighten the mast clamp
assembly's nuts until it securely holds the antenna in a horizon-
tal position. Do not overtighten the nuts.
Follow the guidelines listed in Step 5 to route the coaxial cable
from the antenna into the house.
When you finish making all connections, rotate the antenna to a
position that gives you the best reception.
3
TV or VCR
Satellite Receiver
ANT Connector
Inside Diplexer
SAT/ANT Connector
Antenna In
Connector

Advertisement

loading