How To Operate; Operation / Accessories - Vax HF86-FM-T Instruction Manual

Vax V-102E User Guide v6.qxd

4. How to Operate

Cord Release
Fully unwind the power cord. A yellow mark on the power
cord indicates the recommended cord length. Do not
exceed the cord length beyond the red mark.
On/Off Button
Insert the power plug into the electrical outlet. Ensure the
vacuum cleaner is switched off.
Press the on/off button located on the top of the vacuum
cleaner and press the button again to turn the vacuum
cleaner off.
Combination Floor Tool
Carpet Cleaning:
For carpet and rug cleaning press the rocker switch
on the combination floor head to raise the brushes.
Hard floor cleaning:
For hard floor cleaning, press the rocker switch on the
combination floor head to lower the brushes.
Cord Rewind
To rewind the power cord, press the cord rewind button,
located at the rear of the vacuum cleaner, and guide the
power cord with one hand. This will prevent the cord from
whipping which could cause damage or injury.
Variable Power
Located between the on/off and cord rewind buttons
there is a variable power dial. Press the '+' button to
increase suction power and the '-' button to reduce the
suction power.
Carry Handle
Use the carry handle located at the front of the vacuum
cleaner to move from room to room.
Hose Storage
For convenience there is a slot located located on the back
and underside of the vacuum cleaner where the extension
tube can be parked for carrying and storage.
15/8/07 16:25 Page 5
5. Accessories
The accessories can be attached directly to the handle by
removing the telescopic tube and pushing in the desired
accessory.
The accessories can also be attached to the telescopic
tube for extra reach. Remove the combination floor head
and push on the desired accessory.
NOTE: The crevice tool and 2-in-1 tool are stored in the
lid of the machine above the dust bag compartment.
Crevice tool: for crevices, corners and cracks, etc.
2-in-1 tool:
Dusting brush: for delicate surfaces.
Upholstery tool: for carpets, upholstery, stairs, etc.
TurboBrush: for large carpeted areas.
NOTE: The TurboBrush is not recommended for use on
hard floors
TurboTool: for pet hair, stair and upholstery cleaning
NOTE: Do not use the TurboTool on suede and leather
surfaces.
Hard floor tool: for hard floor, parquet and laminate
coverings.
V-102E

operation / accessories

5